Garbia Group services

Geotechnical Testing

In-situ and laboratory testing of recovered soil samples to establish strength, classification, and settlement behaviour.

What the work involves

In-situ measurements taken during drilling, combined with laboratory work on the recovered samples, to put numbers against each layer: density and consistency, shear strength, compressibility, and classification. These are the values the structural designer's bearing-capacity and settlement calculations are built on.

The problem it solves

Sample descriptions alone cannot tell you strength, classification, or how much a layer will settle under load.

Where it applies

Any project where foundation loads must be justified numerically.

FAQ

Geotechnical Testing FAQs

Answers to common questions about geotechnical testing in the Philippines.

  • SPT is the most common in-situ test in soil investigation, carried out to ASTM D1586. A split-spoon sampler is driven into the bottom of a borehole by a 63.5 kg hammer falling 760 mm. The number of blows needed to drive each 150 mm increment is recorded, and the blows for the second and third increments give the N-value. That N-value correlates with the soil's density and strength, and it also recovers a disturbed sample for laboratory classification.
  • Classification and index tests establish what the soil is: moisture content, specific gravity, Atterberg limits (liquid limit, plastic limit, and the resulting plasticity index, to ASTM D4318), and grain size distribution. Performance tests establish how it behaves under load: consolidation testing for settlement, unconfined compression for undrained shear strength, permeability for water flow, and field density and maximum dry density for compaction control. For pavements and roads, California Bearing Ratio (CBR) and Los Angeles abrasion testing are used.
  • Field and laboratory testing follow ASTM standards and the specifications applying to the project — for example ASTM D1586 for Standard Penetration Testing, ASTM D4318 for Atterberg limits, ASTM D2435 for one-dimensional consolidation, and ASTM D1883 for CBR. Philippine projects are also designed against the National Structural Code of the Philippines, and public works are subject to the relevant DPWH requirements.